Loading…
A 38.1 by 25.4 mm four-layer sensor node built for JLCPCB's standard process, with a USB Type-C supply, an STM32 host and a BME280 environmental sensor on SPI.
Interactive model
Orbit the board and look along the connector edge. The viewer loads the published glTF 2.0 binary, so the console renders exactly what a receiving CAD system imports: the board body, the connector body and the component envelope.
The peripheral is a compact, 4-layer PCBA measuring 1500 mil × 1000 mil (38.1 mm × 25.4 mm), engineered specifically for JLCPCB's standard (non-HDI) fabrication process. Supply chain resilience and assembly cost-efficiency were prioritized during BOM selection through three strict criteria: minimum inventory thresholds of 10,000+ units, preferential selection of LCSC Basic parts to eliminate extended-component setup fees, and full English datasheet availability.
Power is delivered via USB Type-C (), with a typical operating draw under and a maximum budget of . Power traces and planes are sized accordingly to minimize losses and thermal rise. Active component decoupling networks, primarily utilizing high-frequency bypass and bulk ceramic capacitors, were dimensioned directly from manufacturer datasheet transient and peak current specifications.
The STM32 microcontroller interfaces with the BME280 environmental sensor over a dedicated SPI bus. Dedicated tactile switches for NRST and BOOT0 are integrated on-board to simplify hardware debugging, recovery, and DFU/UART firmware flashing.
Send the stackup, the interface list and the manufacturing package inputs. An engineer re-solves them against the real layout before the fixed fee is issued.