Each case study pairs the real physical numbers with a 3D assembly built from the native ECAD export. Orbit the board, check component density, look at connector orientation, and read the constraints that actually governed the routing.
Every entry is a board that was laid out and built. Each ships a glTF 2.0 binary the browser renders, a cover image generated from that same file at build time, and a write-up covering the routing constraints, the trade-offs, and where the fabrication limits sat.
Selected Work
Published Projects
Pick a project to inspect the 3D assembly, the physical dimensions, and the design log. The glTF 2.0 model stays downloadable, so you can open it in another viewer or CAD tool.
PCB Layout
Four-Layer Design
USB Type-C
STM32
STM32 Environmental Node: A BME280 On A Four-Layer USB-C Board
A 38.1 by 25.4 mm four-layer sensor node for JLCPCB's standard process: USB Type-C power at 50 mA typical, LCSC Basic parts, an STM32 host and a BME280 on SPI.
USB-to-UART Bridge: 90 Ω Pair on a Four-Layer Stack
Built twice: a 25.4 mm square USB-to-UART bridge that takes Type-C into a CP2102N and out to a four-pin header, with the TVS clamp ahead of the silicon and the fanout pushed to Layer 3 to keep Layer 2 continuous. The 0.126 mm pair and 0.127 mm gap are set from the stackup for a 90 Ω target, and Rev B rewires a TVS array that Rev A had on the wrong pins.
Two-Layer 12 V to 3.3 V Buck: Placement, Plane and Thermal Path
A 3.3 V, 3 A buck built around the TI LMQ66430 in 32.4 by 25.4 mm on two layers at 0.41 mm: C1 sits 3.3 mm from the VIN and PGND pins, the terminals sit on opposite edges, and the output rail runs 1 mm wide for the full 3 A. The bottom layer is the input loop's return path and the heatsink, tied to the exposed pad through one 0.71 mm via with no relief spokes.
Each entry holds an interactive 3D rendering of the assembly, a write-up of the layout decisions, and the glTF 2.0 model that both the viewer and the cover image are built from.
Yes. Each project page links the published glTF 2.0 binary as a direct download. It is the same file the viewer renders and the cover image is generated from, so what you import matches what you inspected.
Send the schematic netlist, the mechanical constraints, and the packages you plan to use. We check density, the critical routing channels, and the footprint limits before quoting a fixed price.