Loading…
Most fabrication holds come from a step that was assumed instead of checked. This checklist follows the work from netlist intake to the release package and names the items that decide whether the board builds cleanly.
Intake
The first two items catch the defects that are cheapest to fix. A wrong footprint found after routing forces a re-route of every net that touches it, and a missing pin-one orientation reaches assembly as a reversed part.
Routing
Routing order is a schedule decision as much as an electrical one. A board routed in the order of its difficulty keeps the escape channels open for the interfaces that need them, and it avoids the late discovery that a matched group cannot reach its window.
Verification
The review that matters is the one performed by someone who did not route the board. A second reader catches the mirrored connector, the missing courtyard and the net that was renamed after the schematic changed.
Run the Netlist Checker before intake, size the stack with the PCB Stackup Planner, and price the scope with the PCB Layout Cost Calculator.
Release
Gerber X2 is the default fabrication output, with ODB++ and IPC-2581 supplied alongside it for fabricators that read them. NC drill, the BOM and pick-and-place data travel in the same package, and the native Altium project ships with it so the design stays editable.
Name the files so the fabricator can match them to the drawing, and put the revision on every layer and every document. A release whose revision is only in an email is a release that will be built twice.
Finally, archive the package that was actually sent. The next revision starts from that archive, not from a folder that may have changed after shipment.
FAQ
Send the stackup, the interface list and the board release inputs. An engineer re-solves them against the real layout before the fixed fee is issued.