Loading…
A controlled impedance board is a contract between the stackup, the fabricator and the routing. The target sets the geometry, the tolerance sets the process, and the coupon proves the two agree before the panel is etched.
Geometry
Impedance is a property of the whole cross-section: trace width, dielectric height, copper thickness and the permittivity of the material. Fixing a number in the net class does not create it. The geometry has to be solved on the layer that will carry the trace, with the dielectric the fabricator will press.
A microstrip on the outer layer and a stripline on an inner layer reach the same target with different widths because their fields sit in different amounts of dielectric. Treat each layer as its own problem, and record the solved width per layer on the fabrication drawing.
Differential pairs add spacing to the equation. The pair target is set by width and gap together, and a change in one moves the other. Solve the pair as a set, then check the single-ended impedance of each leg if the receiver cares about it.
Process
A target without a window is not a specification. The window comes from the interface and from the fabricator's etch control, and it has to be written down before quoting. A common planning value is plus or minus five percent for the routed trace, with the laminate permittivity adding its own lot-to-lot spread.
Etch bias moves a width by a fixed amount per side, which is a larger fraction of a narrow trace than of a wide one. That is why a fine-line layer is harder to hold than a coarse one, and why the tolerance should be checked against the actual width rather than assumed.
Ask the fabricator what they can hold on the stack you have chosen. A process that holds a tight window on one construction may not hold it on another, and the answer belongs in the stack drawing while the geometry can still change.
Solve each layer in the PCB Impedance Calculator, check the offset and dual-Dk cases in the Asymmetric Stripline Calculator, size the current paths in the Trace Width Calculator, and compare the result with the process envelope on the PCB layout capabilities page.
Routing
An impedance-controlled trace needs a continuous reference plane for its whole length. A plane split, a void for a via field or a connector antipad changes the return path and the impedance at the same moment, and the discontinuity shows up as reflection and crosstalk.
Keep the pair reference on one plane from driver to receiver. A layer change moves the return current to a different plane, so add a stitching via or capacitor next to the transition. The same rule applies to the AC coupling capacitors and the connector launch.
Differential pairs also need matched lengths inside the pair. The skew budget comes from the interface, not from a habit; convert it to a length window at the propagation delay of the layer, and check the window after the final route rather than during it.
Verification
A test coupon is a small impedance test structure built beside the panel. It carries the same trace widths and stackup as the design, and it is measured with a time-domain reflectometer after fabrication. Without it, the impedance claim rests on a calculation nobody verified.
Place coupons for every impedance class on the panel and label them on the fabrication drawing. Ask for the measured result with the shipment, and compare it with the target window before assembly. A coupon that disagrees with the calculation is the earliest warning that the stack or the etch process moved.
Record the target, the tolerance, the coupon location and the measurement in the release package. That record is what makes the next revision faster and what makes a fabricator change auditable.
FAQ
Send the stackup, the interface list and the controlled impedance inputs. An engineer re-solves them against the real layout before the fixed fee is issued.