Loading…
A stackup is a manufacturing decision before it is an impedance decision. Layer assignment, dielectric height and copper weight decide which trace geometries the fabricator can hold, so the stack is designed against a real process window and the widths follow from it.
Layer Plan
The first pass assigns copper, not trace widths. Every signal layer needs an adjacent continuous reference plane, power and ground earn their own layers once the board passes four, and the outer layers carry the parts that need the shortest escapes.
Count the interfaces before you count layers. A board with DDR, PCIe and a dense connector field needs signal layers with a clean return path and at least one full plane for each supply domain. A sensor board with one regulator often fits on four layers with a single ground plane and a careful placement.
Treat plane splits as a last resort. A split under a mixed-signal part usually lengthens the return path for the fast nets crossing it. A single ground plane under both sections, with the conversion point placed deliberately, keeps the loop small and the impedance continuous.
Materials
Impedance is a function of trace width, dielectric height and the permittivity of the material between them. The height comes from the prepreg and core the fabricator stocks, so ask for the stocked constructions and their pressed thickness before solving for a width.
On a four-layer board the outer dielectric is often one prepreg sheet, which puts microstrip impedance near the edge of what a narrow trace can hold. Adding a second sheet changes the height, the width and the loss at once, so solve the set together rather than one number at a time.
Send the fabricator the impedance target and let them map it onto their inventory. Their etch process moves a width by a small but real amount, and a target survives that move where a nominal width does not. Record the target on the fabrication drawing with the layers it applies to.
Build the stack in the Stackup Planner, solve each layer in the PCB Impedance Calculator, check the delay on the Propagation Delay Calculator, and compare the result against the process limits on the PCB layout capabilities page.
Fabrication
Balanced copper keeps the board flat through reflow. Layer pairs should mirror in copper weight and dielectric thickness, and a large pour on one side needs a counterpart on the other. Asymmetric builds bow after lamination and cause placement problems long before they cause electrical ones.
Write the stack on the fabrication drawing with material names, finished thickness and copper weight. The drawing is what the fabricator quotes against, and a mismatch between that drawing and the CAD stack is a routine source of rework.
Check the drill schedule against the via spans the design uses. A through via from layer one to layer six is one process; a blind via from one to three is another, and the stack has to state which one the routing assumes. The same rule applies to backdrilled vias: the depth belongs on the stack drawing, not in a note that travels separately.
Review
FAQ
Send the stackup, the interface list and the stackup inputs. An engineer re-solves them against the real layout before the fixed fee is issued.